The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

mplex2000 · 10-24-2005, 10:45 AM

Posted this over in Engine and Drivetrain, but I never get any answers there so here it is again:

I'm wanting to retrofit my old 350 block with a roller cam. None of the grinds out there will work real well for me, though.

I was looking at a "stock" ZZ4 cam which is a nice mild looking grind. Can this cam be installed in an older non roller block using the typical aftermarket roller retrofit lifters?

Thanks,
Chris

10-24-2005, 10:45 AM	#1
mplex2000 Registered User Join Date: Jul 2005 Location: DFW Posts: 463	Roller cam conversion question Posted this over in Engine and Drivetrain, but I never get any answers there so here it is again: I'm wanting to retrofit my old 350 block with a roller cam. None of the grinds out there will work real well for me, though. I was looking at a "stock" ZZ4 cam which is a nice mild looking grind. Can this cam be installed in an older non roller block using the typical aftermarket roller retrofit lifters? Thanks, Chris Last edited by mplex2000; 10-24-2005 at 10:46 AM.