|
Re: 67 SWB with must II front & 4 link rear.
Quote:
|
Originally Posted by 1976K5CHALET
N2trux...i see you are using the kit for your front end but what intriuges me is the whole frame appears to be cut off and a custom front clip if you will has been installed which leads me to question number 2...is that an newer LT1 lurking under there? Early this year one of the 4wd rags did a article on how to fit one in your 81 up k5....looks like this is the better way to go...
Doug W.
|
Yes, N2TRUX's front frame rails are custom pieces that were fabbed specifically to place the 'Scott's' front end exactly where it needed to be. And FirstGen is right.... it's an LS1.
The guys that are building Kens Blazer would use a 'kit' if there was one available but the parameters set for his build-up necessitated using that front end. If they had it to do over again, I don't think they would use Scotts stuff.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|