|
Re: quicky how to on throw out bearing?
Quote:
|
Originally Posted by Tx Firefighter
Fellows, you're scaring him too much.
You do not need to unbolt the bellhousing from the engine. That's an unecessary trip to take
Remove the driveshaft, speedo cable and shift linkage. Now, unbolt the trans from the bellhousing. There will be two forward facing bolts and two rearward facing bolts. The bellhousing can remain attached to engine through the whole deal.
Once the trans is off the bellhousing, reach in and pop a new bearing into the clutch fork. Reinstall the trans.
It's a hour job.
|
That's how my dad and I changed mine before I put in the 700R4, It took us about 2 to 3 hours.... Tx must be a pro 
Last edited by 67ChevyRedneck; 12-20-2005 at 05:00 PM.
|