The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Blazer Tub off the frame experience needed

jcfoote60 · 12-28-2005, 10:08 AM

thanks 71restoRod, did you use the rear seat bolt in locations for lifting the rear with your engine hoist, it looks that way. Also I am not clear on where you hooked onto the front of the body to lift it with the engine hoist?? I have a barn so I might be able to build a similar scafolding. With the 2 x 10's holding up the body did you have any concerns getting under the body to work on it? Or I guess you didn't have to, however I plan on doing the underneath of the tub and body before I lower it back onto the frame (once it's done)

12-28-2005, 10:08 AM	#6
jcfoote60 Active Member Join Date: Jun 2005 Location: Idaho Posts: 263	Re: Blazer Tub off the frame experience needed thanks 71restoRod, did you use the rear seat bolt in locations for lifting the rear with your engine hoist, it looks that way. Also I am not clear on where you hooked onto the front of the body to lift it with the engine hoist?? I have a barn so I might be able to build a similar scafolding. With the 2 x 10's holding up the body did you have any concerns getting under the body to work on it? Or I guess you didn't have to, however I plan on doing the underneath of the tub and body before I lower it back onto the frame (once it's done)