The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

bighead · 02-08-2006, 09:46 AM

For me the ultimate would be a piece of jig plate with a grid of drilled and tapped 3/8ths holes covering it. This would rest on a steel frame with adjustable feet. Fixtures could be built and bolted to the table to position and clamp the tubing. That being said, my current drag car project was fabbed on a stainless table with a smooth top about 16' long and 4' wide.

02-08-2006, 09:46 AM	#4
bighead Registered User Join Date: Nov 2005 Location: McKinney, Texas Posts: 465	Re: Building a frame table/Jig table... For me the ultimate would be a piece of jig plate with a grid of drilled and tapped 3/8ths holes covering it. This would rest on a steel frame with adjustable feet. Fixtures could be built and bolted to the table to position and clamp the tubing. That being said, my current drag car project was fabbed on a stainless table with a smooth top about 16' long and 4' wide.