View Single Post
Old 02-19-2006, 10:40 PM   #1
Russell
Professional Grade
 
Russell's Avatar
 
Join Date: May 2003
Location: Fort McMurray, Alberta
Posts: 7,915
Source for junction block connectors?

Howdy!

I've finally got my GMC's electrical sorted out to the point that I am ready to start hooking stuff up. However, I want to route some new wires through the junction block instead of routing it through grommets in the firewall, and have found it nearly impossible to re-use those pins. Their tabs just snap off at the slightest bit of movement, even if you apply lots of heat.

Does anyone know if anyone sells those pins aftermarket? I need like 15 of them, and the HELP! section dealies are 2 bucks a peice :eek1:

Anyone have any suggestions? Or should I just do the ol' through the grommet type connections?
__________________
1995 Chevrolet 2 Door Tahoe (6.6L LBZ Duramax / ZF6 / NP241 with 1 ton solid axle swap)
Russell is offline   Reply With Quote