The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Replacing Dana 44 Axle Shaft U-Joints

Erl · 02-28-2006, 02:31 PM

I am trying to replace the U-Joints in my Dana 44 3/4 front axle. The yokes have caps on the ends where the clips normally are located. These use a C-Clip on the inside of the yoke. How do the U-Joints come out?

02-28-2006, 02:31 PM	#1
Erl Registered User Join Date: Mar 2002 Location: Dallas, TX Posts: 555	Replacing Dana 44 Axle Shaft U-Joints I am trying to replace the U-Joints in my Dana 44 3/4 front axle. The yokes have caps on the ends where the clips normally are located. These use a C-Clip on the inside of the yoke. How do the U-Joints come out? __________________ 1968 GMC 305 V6 3/4 4x4 Stepside 06 Corvette Daily Driver Dallas TX Last edited by Erl; 02-28-2006 at 02:32 PM.