The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

sweet n rare67 · 03-24-2006, 01:58 PM

The v8's and the I6's do sit in a different location...the I6 engine mounts bolt into the back two holes on the frame where as the v8's engine mounts bolt in the front two holes...The swap back shouldnt be a problem depending on what tranny crossmembers you have. I am not sure if this all apply's the same on a 4x4 but I believe that it would.... If you decide to do this and need the I6 Engine towers, just Let me know.
-Jake

03-24-2006, 01:58 PM	#2
sweet n rare67 Young truck fanatic Join Date: Jun 2003 Location: The wonderful Mat-Su Valley....Palmer, Ak Posts: 253	Re: SBC to Inliner........Motor mounts? The v8's and the I6's do sit in a different location...the I6 engine mounts bolt into the back two holes on the frame where as the v8's engine mounts bolt in the front two holes...The swap back shouldnt be a problem depending on what tranny crossmembers you have. I am not sure if this all apply's the same on a 4x4 but I believe that it would.... If you decide to do this and need the I6 Engine towers, just Let me know. -Jake __________________ '67 Chevy Longstep 2wd 350 w/4spd manual Muncie M21. My first project. Proud to be Valley Trash