The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - A little progress on my suspension, 2wd bags

**71swb4x4** · 03-26-2006, 12:55 AM

The valves do not hang below the frame at all. I will probably mount a piece of aluminum under the tank and valves to try to keep some dirt and water away, but this is going to be a fair weather vehicle anyway.

In the rear I am going to run a three gallon tank, it will be just outside the frame rail on the passengers side. The front and rear tank will be tied together with 1/2 air line. Both tanks will be fed by a York compressor.

I hope to have all of this done by mid May. I only get a few hours a week in the garage, so this will be a long project.

03-26-2006, 12:55 AM	#2
71swb4x4 Senior Member Join Date: Nov 2003 Location: Brookings, SD Posts: 10,499	Re: A little progress on my suspension, 2wd bags The valves do not hang below the frame at all. I will probably mount a piece of aluminum under the tank and valves to try to keep some dirt and water away, but this is going to be a fair weather vehicle anyway. In the rear I am going to run a three gallon tank, it will be just outside the frame rail on the passengers side. The front and rear tank will be tied together with 1/2 air line. Both tanks will be fed by a York compressor. I hope to have all of this done by mid May. I only get a few hours a week in the garage, so this will be a long project.