[Bowtie67]

Put the front & Rear suspension on the new frame, installed Motor, Transmission, driveshaft, drilled hole in passenger side header and installed an O2 sensors bung as well as the O2 sensor for the LM1 and then installed headers and finished up welding crossover pipe and then installed that as well as the dyna mufflers(stopped at rear axle) remade different and better crossmember for transission. Painted calipers, installed power steering pump and madeup & installed power steering lines. Hopefully today I will get the fuel cell mounted, install front calipers/brakes makeup my brake/fuel & tranny lines and installed along with my emergency brake cable all setup.