The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

70 longbed · 04-03-2006, 02:03 PM

I know you said you didn't want to cut, but there is a connector out there that is easy to use, solders and seals all in one and makes a water tight connection. Cut, one wire one end, two wires the other end, heat and you are done; melts the solder for the wires and the glue in the sleeve. I will look and see if I can get a manufacturer. Go out to WAYTEK wire and look around, they have alot of stuff.

04-03-2006, 02:03 PM	#14
70 longbed Senior Member Join Date: Oct 2002 Location: Sierra Vista, AZ Posts: 489	Re: Proper way to tap into a wire I know you said you didn't want to cut, but there is a connector out there that is easy to use, solders and seals all in one and makes a water tight connection. Cut, one wire one end, two wires the other end, heat and you are done; melts the solder for the wires and the glue in the sleeve. I will look and see if I can get a manufacturer. Go out to WAYTEK wire and look around, they have alot of stuff. __________________ Keith 70 CST longbed in progress. Hoping to get it back on the road soon.