The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

qksilver · 04-15-2006, 12:16 AM

I am parting out an 87 LWB 1/2 truck. I have the complete dual tank set up from the frame brackets, tanks, plastic shields, cab switch, wiring, metal inlets and inner housing from bed, gas lines, mechanical switch on frame , EVERTHING from the fuel filter back(hard parts), inside cab stuff and wiring? Not sure if the fuel pump s are in the tanks or on the frame. I haven't pulled the bed will do it today.
I drove the truck into my shop, gauges worked and engine ran from both tanks........they were holding gas.
pix on request after i pull it.
150.00 bucks most of it labor or best offer?
I am 15 miles from Fort Bragg NC, pick up only, don't think they accept used tanks to ship
Thanks,
Steve

04-15-2006, 12:16 AM	#1
qksilver Senior Member Join Date: Dec 2004 Location: Southern Pines NC Posts: 3,853	any need or interest in dual tank set up I am parting out an 87 LWB 1/2 truck. I have the complete dual tank set up from the frame brackets, tanks, plastic shields, cab switch, wiring, metal inlets and inner housing from bed, gas lines, mechanical switch on frame , EVERTHING from the fuel filter back(hard parts), inside cab stuff and wiring? Not sure if the fuel pump s are in the tanks or on the frame. I haven't pulled the bed will do it today. I drove the truck into my shop, gauges worked and engine ran from both tanks........they were holding gas. pix on request after i pull it. 150.00 bucks most of it labor or best offer? I am 15 miles from Fort Bragg NC, pick up only, don't think they accept used tanks to ship Thanks, Steve Last edited by qksilver; 04-15-2006 at 12:18 AM.