[mdlackey]

May I please ask that someone take a pic of their "properly setup and functioning" clutch linkage ... from the engine bay, looking at where the pedal-to-z-bar linkage comes out of the firewall and then of the z-bar itself ... ??? Also, may I please ask for a pic of where the z-bar attaches to the motor-side mount ... ???

If you could post them in a "Reply" to this Post, I'd GREATLY appreciate it ...

Mine is sitting at an unusual angle and I'm concerned about unnecessary torque being put on the entire linkage assembly, leading to failure.

I may build my own linkage with aluminum rods and spherical bearings ... will post pics, when complete.

Thanks,
Dave