If only the factory made them this strait! It is hard to see it in the first pic but the upper gap is 5/16" and the bottom went out to 1/2". I ended up adding a 1/8" rod tight at the top of the door and by th etime it was at the botom bottom of the door I had brought it out to 1/4". Then on the Jamb I used 1/8" rod at the bottom to just above the lower body line and then changed to 1/16" rod from their to about center of the jamb. Once they were welded up on both sides and gound smooth I then shut the door and took an .040 think cutting wheel on a diegrinder and cut the gap strait and to an 1/8" top to bottom. All it needs now is a build primmer and block sanding. I like this kind of stuff. I can't wait to get started on "Project Lemon Drop" , it is all about 1/8" gaps every where and a bunch of other cool mods. The best part is their is absolutly ZERO rust repair to do to it
Kevin
LFD Inc.