[Crush]

Spent Saturday pulling out the brake booster/master cylinder and prepping the surface for the hydroboost unit. Also while the engine bay was somewhat uncluttered I installed the headers with a Stage8 bolt kit and Percy's Seal-4-Good Dead-Soft gaskets. Pretty nice setup once it was finished. While Under the hood I got the radiator straightened out for now, but really just need to make a cowl support for it, the factory one doesn't really fit the new radiator very well. Got a few little wiring issues straight and started getting ready to pull the bed back off to start on the rearend and fuel cell.

One tidbit that I'm sure everyone has run across.....seems that the tranny crossmember on the driver side is going to impeed my exhaust system...any ideas on custom crossmembers?