Quote:
|
Originally Posted by Shane
The seville rotor will NOT fit the stock axle hats. You will need to machine the outside diamter by abotu .050 - .075" ... you will also need to machine the center "nub" approximately the same amount.
I did this mod several years ago and that is the best I can remember how much that needs to be machined off.
|
I figured I would have to machine the axle shaft hats a bit...I have a set of Superior ChroMo axles for the axle so there is no time like the present to take them to my machinist and have them milled down a bit.
Chris