Re: What's a Driveshaft for TH400 in a SWB cost?
Krue,
You won't be able to use your bolt on yoke without the bolt because it will leak unless you plug it somehow, but you can use a regular slip yoke in it's place. Also there's an o-ring up inside on the output shaft you will have to remove to allow it to slip. You could possibly shorten your existing driveshaft depending on it's construction, I have done this a few times.Take it to a driveshaft shop and let them check to see if they can do it.
Mike
__________________
Mike
Castro- 72 SWB. Ochre and White. 496/400 turbo, GV OD ,Dakota Digital dash , tilt, Vintage Air, PS, hydro boost, factory buckets, console, QA-1 Coil over suspension, 20/20"Billet Specialties Magnetos
72 SWB. Med blue. 454/400 turbo, tach, tilt, Stock AC, PS,PDB, factory buckets, console, ECE 4/6 drop w/ 2" blocks and C-notch, 20/20"Coys- Crashed and destroyed by drunk driver Sept 2019. New 72 build in the works.
My new build thread "Castro"
https://67-72chevytrucks.com/vboard/...d.php?t=820934
My old build thread, the blue truck
http://67-72chevytrucks.com/vboard/s...d.php?t=271489
www.louisianaclassictruckclub.com
|