The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

QKENUF4U · 08-20-2006, 09:24 PM

the back port is hooked up to my brake booster (vacumn source) if you dont need it you can block it off
i have the cable gas pedal setup and just used the small ball attachment from my old carb (or it was with the new carb ?) just look at your old carb and youll see the way the cables mounted up. i just picked the right hole for the job and hooked my cable to that. check out the pic.
the top hole is for throttle and the bottom hole is for your kickdown (where i have my spring attached)

08-20-2006, 09:24 PM	#2
QKENUF4U Senior Member Join Date: Jan 2005 Location: SUNNY WARM BIKE RIDING COTTONWOOD ARIZONA Posts: 2,097	Re: Edelbrock Throttle Linkage? the back port is hooked up to my brake booster (vacumn source) if you dont need it you can block it off i have the cable gas pedal setup and just used the small ball attachment from my old carb (or it was with the new carb ?) just look at your old carb and youll see the way the cables mounted up. i just picked the right hole for the job and hooked my cable to that. check out the pic. the top hole is for throttle and the bottom hole is for your kickdown (where i have my spring attached) Attached Images Last edited by QKENUF4U; 08-20-2006 at 09:25 PM.