The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - do you have a air suspension plumbing diagram

7deuce · 09-03-2006, 10:51 PM

No matter where you put the valves you should fly up with 1/2 in valves and line. I reduced my back to 3/8 because it was WAY to fast for me. If you were to sit on the tail gate it would blast you off. NO NEED. Unless your going to hop it. And as far as mountint the valves to the tank. Just use a black pipe nipple not brass comming out of the tank. Brass will and has cracked when used there.

09-03-2006, 10:51 PM	#7
7deuce Sold! 2 days after finished Join Date: Oct 2005 Location: Ohio Posts: 327	Re: do you have a air suspension plumbing diagram No matter where you put the valves you should fly up with 1/2 in valves and line. I reduced my back to 3/8 because it was WAY to fast for me. If you were to sit on the tail gate it would blast you off. NO NEED. Unless your going to hop it. And as far as mountint the valves to the tank. Just use a black pipe nipple not brass comming out of the tank. Brass will and has cracked when used there.