|
Re: Progress pics - air system, not far...yet
Quote:
Originally Posted by gringoloco
Get anywhere with the York yet? Tossin' around ideas of an EDC too...
-Chris
|
I have a boardmember working on brackets. I haven't gotten anywhere so I haven't bugged him about them.
Quote:
Originally Posted by jimmydean
I don't understand why you ran a bulkhead fitting for the crossmember though. Looking at the install diagram I have, they just ran a hose from the bag to the valve.
|
I will take another look at it. If I can cleanly run the lines without them rubbing anywhere I may get rid of the bulkheads, the less fittings the better.
Quote:
Originally Posted by 67Fleet
I also can't see why you needed to cut holes in the floor to get to the upper bag mounts in the rear. Granted I've got a P/U but I didn't even remove the bed to mount the bags and plumb everything.
|
I couldn't get me hand up in there to bolt the bags in. The bolts where spaced far enough apart that one was really close to the frame and the other close to the cup. Since there was already a huge hole in the floor cut by the PO I decided to go that route. If I could have had my truck on a lift I think I could have gotten by without cutting the holes.
__________________
Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs.
|