The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Where do I run the vacuum for my power booster?

jimmydean · 09-20-2006, 01:50 PM

I have an Edelbrock Performer manifold that has a few locations, but I wasn't sure if that was where I ran it to. Right now the only vacuum I have is running from the HEI to the carb. Do I just install a fitting on the back of the manifold and run it from there? I feel like a jackass because I didn't pay attention when I pulled it off the donor.

09-20-2006, 01:50 PM	#1
jimmydean Registered User Join Date: May 2005 Location: Beaverton, OR Posts: 3,728	Where do I run the vacuum for my power booster? I have an Edelbrock Performer manifold that has a few locations, but I wasn't sure if that was where I ran it to. Right now the only vacuum I have is running from the HEI to the carb. Do I just install a fitting on the back of the manifold and run it from there? I feel like a jackass because I didn't pay attention when I pulled it off the donor.