The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PBFAB.COM · 10-27-2006, 03:11 PM

You should be able to unbolt the 87 crossmember and bolt it into the 66 frame. There will be one hole on each side that doesn't line up and will need to be drilled. If its an 88 front end then you will need to get the torch and the welder ready!

10-27-2006, 03:11 PM	#2
PBFAB.COM Senior Member Join Date: Dec 2003 Location: Mesa,Az Posts: 3,981	Re: 87 to 66 front clip? You should be able to unbolt the 87 crossmember and bolt it into the 66 frame. There will be one hole on each side that doesn't line up and will need to be drilled. If its an 88 front end then you will need to get the torch and the welder ready! __________________ www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003! Last edited by PBFAB.COM; 10-27-2006 at 03:11 PM.