View Single Post
Old 11-13-2006, 08:49 PM   #8
Shane
Account Suspended
 
Shane's Avatar
 
Join Date: Jun 2000
Location: over yonder
Posts: 14,270
Re: Cross member rivets

Quote:
Originally Posted by 67Fleet View Post
I take a grinder and cut an X pattern in the rivet, then use an air chisel and knock the head off. Then put a bull point bit in the air hammer and punch the rivet out.
Same here ... X with a Zizz wheel and then the ol' cold chisel and a big a$$ hammer!

Haven't found one yet that wouldn't come out using this method. Although some require a larger hammer than others.
Shane is offline   Reply With Quote