View Single Post
Old 12-19-2006, 04:09 PM   #6
04Xrider
Registered thread killer
 
04Xrider's Avatar
 
Join Date: Nov 2006
Location: Cookson, OK.
Posts: 349
Re: Vin and I6 Motor Identification HELP!!!!!

Unless someone went through a lot of trouble, it is not a 235. As mentioned before, they quite making them in 62. As another mentioned, if the side doors are over 4" then it is a 292. I would suspect it is a 250. There is a engine code by the distributor on the machined area just to the rear of it. You should be able to give that ID# to a dealer and find out what year and cid it is, although I think the year is the first to numbers followed by the first letter. Also you can get the block casting # on the passenger side of the block just under the rear sidedoor, and go here to find what it is. Just to the left of this page you will see a list, click on casting #s and you will probably find a match. Hope this helps. http://www.inliners.org/ The only problem with block casting #'s is that some 230 and 250 shared the same block. The only difference is stroke and pistons.

Last edited by 04Xrider; 12-19-2006 at 04:34 PM.
04Xrider is offline   Reply With Quote