The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Psycho71 · 12-26-2006, 11:34 AM

Hadn't thought about a headache rack. I'll bet that is what it was , and it got snagged on something at some point. Cause just the very front of the bed is tore up. I'll cut out the old, and weld in some new. I can braze it myself, I'm good w/a troch, but I think I'll do it as right as possible. And yep, I'm filling the stake pockets for sure. Never used them on any truck I've had yet. And I'm gonna put a bed cover on it eventually anyway.

Thanks for the advice fellas.

Jay

12-26-2006, 11:34 AM	#7
Psycho71 Registered User Join Date: Jan 2006 Location: Kaufman, Tx Posts: 827	Re: Need Suggestions Please. Hadn't thought about a headache rack. I'll bet that is what it was , and it got snagged on something at some point. Cause just the very front of the bed is tore up. I'll cut out the old, and weld in some new. I can braze it myself, I'm good w/a troch, but I think I'll do it as right as possible. And yep, I'm filling the stake pockets for sure. Never used them on any truck I've had yet. And I'm gonna put a bed cover on it eventually anyway. Thanks for the advice fellas. Jay __________________ You only need two tools in life - WD-40 and Duct Tape. If it doesn't move and should, use the WD-40. If it shouldn't move and does, use the duct tape. If a hammer doesn't fix it, you have an electrical problem! Slot Cars, 1:24 Scale, 100MPH@100,000RPM, fastest things on wheels! Last edited by Psycho71; 12-26-2006 at 11:35 AM.