The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Parts for sale '72 c-10

brak · 12-29-2006, 01:31 AM

laidout - I will be reusing all the suspension components. sorry.

QKENUF4U - yes it was installed in the truck using the stock intermediate shaft. the brackets attached to the column, were bolted directly to the stock mounting holes in the dash. Previous owner made a harness adapter that goes with it. The column seems to be wider than the stock unit, as the previous owner trimmed a little bit of the cluster to make it fit. something i didn't notice until after i removed the column.

one thing i didn't mention is that the signal arm is bent (you can see it in the second pic) and i don't know if the switch itself would need to be replaced, as i only drove the truck once, and that was 5 years ago.

12-29-2006, 01:31 AM	#23
brak Registered User Join Date: Apr 2006 Location: MinneSNOWta Posts: 1,381	Re: Parts for sale '72 c-10 laidout - I will be reusing all the suspension components. sorry. QKENUF4U - yes it was installed in the truck using the stock intermediate shaft. the brackets attached to the column, were bolted directly to the stock mounting holes in the dash. Previous owner made a harness adapter that goes with it. The column seems to be wider than the stock unit, as the previous owner trimmed a little bit of the cluster to make it fit. something i didn't notice until after i removed the column. one thing i didn't mention is that the signal arm is bent (you can see it in the second pic) and i don't know if the switch itself would need to be replaced, as i only drove the truck once, and that was 5 years ago. __________________ 2003 GMC Sierra 1500 WT 1995 Nissan Hardbody 2016 Hyundai Veloster Turbo DC2 (SW/AW) Clyde W. Harvey USN "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery" Winston Churchill Last edited by brak; 12-29-2006 at 01:35 AM.