The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jlaird · 12-29-2006, 11:41 PM

Boatpuller, I was going to cut down the height of the carrier bearing and mount the carrier bearing higher up on the crossmember, but I realized it would be easier to rotate the carrier bearing 180 degrees so the mounting plate is on the bottom and move the bracket to the bottom to hold it up.

What exactly did you do?

12-29-2006, 11:41 PM	#11
jlaird Senior Member Join Date: May 2004 Location: johnstown, NY Posts: 2,393	Re: driveshaft and pinion angles Boatpuller, I was going to cut down the height of the carrier bearing and mount the carrier bearing higher up on the crossmember, but I realized it would be easier to rotate the carrier bearing 180 degrees so the mounting plate is on the bottom and move the bracket to the bottom to hold it up. What exactly did you do?