View Single Post
Old 01-09-2007, 12:28 AM   #7
GMCMAX
Active Member
 
GMCMAX's Avatar
 
Join Date: Jan 2006
Location: Lower Mid-East Ca.
Posts: 326
Re: 2wd to 4 wheel drive swap in progress....ideas?

I flattened out the dimples on mine and plated the outside with 1/4". I heated the frame and used two 1" thick plates with a big bolt and nut through them and sandwiched the frame while it was hot to flatten it. Finished up with a small amount of hammering. That frame is tough! Sorry now I didn't take pics in progress. I did find out with the factory 2wd rear end spring mounts that a 4" block only brought the rear level with a factory front suspension.
__________________
Never try to teach a pig to sing; it wastes your time and annoys the pig!

Gets More Chicks

My lugnuts require more torque than your honda makes!

68 GMC, 4X4 conversion w/73 k20 running gear and springs, 350 4spd, 4.10's, D44 powerlok front, 14BFF govlock rear, 33" tires, lifted 4".
GMCMAX is offline   Reply With Quote