Quote:
Originally Posted by sameyrasmea72
Is pulling the pan the only way to tell for sure?
No you can run the block number on a site like www.mortec.com and it will tell you if it is a 2 or 4 bolt main.
On a side note, I wonder if I am selling these engines too cheap. I have been getting about $400 for a complete non-running 350 engine right out of a truck, and have sold every one of them I can get a hold of. |
Usually in sales if you sell 100% of your inventory your price point is too low. For example selling 100% of your engines for $400 is too low. Try adjusting you price points higher until you reach 85-90% So if you charge $500 per engine and only sell 90% of you are about right, then if your inventory of the remaining amount drop your price a little or hold on to them for a while if you can.