The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jimmydean · 01-19-2007, 04:52 PM

I would think it would be easier to do some sheet metal replacement off the frame. As long as you're not touching the mounts, you're fine.

If you do have to touch the mounts or anywhere that might affect it, measure before/during/after and you're good to go.

01-19-2007, 04:52 PM	#2
jimmydean Registered User Join Date: May 2005 Location: Beaverton, OR Posts: 3,728	Re: Is this going to mess me up? I would think it would be easier to do some sheet metal replacement off the frame. As long as you're not touching the mounts, you're fine. If you do have to touch the mounts or anywhere that might affect it, measure before/during/after and you're good to go.