|
Re: Pulley alignment problems
Just went through this, and Joey67 did too. You have a short water pump. That 2nd pulley is a short water pump PS pulley. You will need either a 3 or 4 groove crank pulley for short water pump to make that work. The short pump crank pulleys fit flush to the harmonic balancer. This is using the cast brackets.
After playing around in the WTB section for over a week I called summit and ordered their 3-groove chrome crank pulley P/N SUM-G3972. It should arrive mid-week and I will report back if it fits or not, but I am pretty confident that it will work great.
__________________
-Chris
Building a stripper, one part at a time: 1969 K5, 307, 3spd, 3 seats, hard top. Added Pwr Discs, Pwr Steering, Aux Battery, T-case Skid, Lighted Sidemarkers, HEI, Lock-Right Diff, ECE Class IV Hitch, 32" MT/Rs. Parts to Install: Hand Throttle, Console, Tow Hooks, Dual Horns, AM-FM, Dealer Swing-Away Tire Carrier, Gas Tank Skid.
Also building a 1950 Willys CJ-3A and off-roading a 2001 Nissan Frontier on 1-Ton Portals...
|