[Aarons72s]

I cut the bulk out but stay away from the front and rear cab corners and inner rocker panel. I then either drill the spot welds out or use a air chisel, depending on my mood and where I am working at. Also I dont weld rockers back in. I bedliner the crap out of both the inner rocker and the back side of the new rocker and drill new drain holes. I then glue and rivit them on. Solving the rust roblem once and for all. Also check the outer edge of the rocker with a straight edge, the lip rigt under the outter edge of the door. Alot of the rockers lately are warped and not straight fron to back.