The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

64shortc10 · 02-05-2007, 02:08 AM

Kenneth_CS87,

Hi, Im running a Porterbuilt dropmember in my 64. I am also running a 94 Trans Am LT1. I still have the A/C in the stock location so I beleive this combo will work for you also. I totally recomend the dropmember, it looks so much cleaner then a cut up Z notch. Good luck!

Nathan,

Still awaiting my rack notches and rack to spindle Heims. Any word on there where abouts? Also still intrested in a price on those hood hinges, and a polished power rack like the one installed on dino's 66? I'm not being pushy,
I'm just excited to finally start purchasing some higher dollar parts.
Thanks again.

Tony from Norcal.

02-05-2007, 02:08 AM	#420
64shortc10 Registered User Join Date: Jan 2007 Location: Winters, Ca. Posts: 1,069	Re: Dropmember in a 69 C10 Kenneth_CS87, Hi, Im running a Porterbuilt dropmember in my 64. I am also running a 94 Trans Am LT1. I still have the A/C in the stock location so I beleive this combo will work for you also. I totally recomend the dropmember, it looks so much cleaner then a cut up Z notch. Good luck! Nathan, Still awaiting my rack notches and rack to spindle Heims. Any word on there where abouts? Also still intrested in a price on those hood hinges, and a polished power rack like the one installed on dino's 66? I'm not being pushy, I'm just excited to finally start purchasing some higher dollar parts. Thanks again. Tony from Norcal.