View Single Post
Old 02-06-2007, 11:32 PM   #2
Jtrux
I'm a poor spectator
 
Jtrux's Avatar
 
Join Date: Aug 2006
Location: San Antonio, Tx
Posts: 2,287
Re: Front Drive Shaft Questions and a Junk Yard Run

Up to 77 dana 44's were located under the front ends of most chevy's ( actually that may be the year when the 10 bolt was introduced so either axle was available, I guess look for pre 77 to be sure) so any one of those pinion yokes should work. Since your gears have been changed to 4.88 ( I read that in the welcome area) it may be different but not likely. As far as driveshafts a custom one is probably in order ( your looking at around 300 bucks). You could pull one off of any 1/2 ton blazer, truck, suburban and have it lengthened too but I personally would go new on that, but that's just me.
__________________
2006 Jeep Unlimited IMPACT ORANGE

1993 Chevy 2500 4x4 ExCab LWB 454/NV4500 Tow rig

1977 Ford F100 2x4 LWB 1st truck I owned, still have it!!!

1979 Ford F150 4x4 SWB Built Ford Tough!!!

1971 Chevy Blazer 350 / SM465 / NP205 UNDER CONSTRUCTION Soon to have a LQ4 6.0!!!
Jtrux is offline   Reply With Quote