Quote:
Originally Posted by babyblueoval
Brad,
Nathan designed the dropmember to run at a 5" ride height.
2wd will need drop spindles and will put the frame rails on the ground.
4wd with stock spindles will do the same.
On Kyle's blazer in the 69-72 Blazer forum, the rear has been c-notched so the bottom of the "c" is the same height as the top of the rest of the rail.
|
these figures are also based on a 29'' tire (right Nathan?) I think if you used a 27'' I'm pretty sure a 2wd can still lay frame with stock spindles.