[Yukon Jack]

Don't cha hate it when you go out to make some progress on something and you end up a few steps back from where you started?

Case in point, went out to do brake line work yesterday afternoon (yes that is not a typo - I got to work on my K5 during the day!). I was going to bend up the new front brake lines but decided first I woud redo the master cylinder lines so the correct lines were going to the correct spot on the proportioning valve. Of course the fittings on the master and the cylinder are all different so rather than just being able to flip the porportioning valve I had to take the old lines, cut them, then put a fitting from this line on that line and vise versa. Got one line done simply enough but the second line I had to redo over and over - kinked it once, screwd up a bend too bad to fix a second time, then ran out of 1/4" line.

So, there ya go, one step back + no work on the actual front brake lines.