The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PBFAB.COM · 02-26-2007, 12:47 AM

Time for an update....

The back-half is nearing completion... should have some 'finished pics' up the end of the week. These 'teaser pics' will have to do for now.

The BBC mounts are done. I had to raise the mounting tabs 3/4" for oil pan to rack clearance. I am hoping to roll a frame into the shop and mock it up with a cab in place for clearance pics. Clearance at the fire-wall should be OK... I will know for sure this week... worst case, the trans tunnel will need some mods at the firewall.

02-26-2007, 12:47 AM	#466
PBFAB.COM Senior Member Join Date: Dec 2003 Location: Mesa,Az Posts: 3,981	Re: Dropmember in a 69 C10 Time for an update.... The back-half is nearing completion... should have some 'finished pics' up the end of the week. These 'teaser pics' will have to do for now. The BBC mounts are done. I had to raise the mounting tabs 3/4" for oil pan to rack clearance. I am hoping to roll a frame into the shop and mock it up with a cab in place for clearance pics. Clearance at the fire-wall should be OK... I will know for sure this week... worst case, the trans tunnel will need some mods at the firewall. Attached Images __________________ www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003!