The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

CustomChevy · 11-19-2002, 08:32 PM

hello,

fist you need a magnetic protractor, available at sear's for $10.

rear axle needs to be inclined at 3 degrees (to offset motor/tranny declination of 3 degrees.

as long as motor/tranny declination angle is canceled out by rear axle inclination, then you are good to go.

hope this helps.

11-19-2002, 08:32 PM	#7
CustomChevy Registered User Join Date: Nov 2002 Posts: 461	3 degrees hello, fist you need a magnetic protractor, available at sear's for $10. rear axle needs to be inclined at 3 degrees (to offset motor/tranny declination of 3 degrees. as long as motor/tranny declination angle is canceled out by rear axle inclination, then you are good to go. hope this helps.