The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PBFAB.COM · 03-03-2007, 04:49 PM

The Big Block mounts are done. I shipped the first Dropmember BBC combo out this week. The motor mount tabs for the BBC set up 3/4" higher than the SBC and the mounts themselves are all the same. I am yet to mock it all up in a cab to see exactly where the fit issues lie. I am assuming some slight mods to trans tunnel where it meets the firewall will be needed (maybe 1/2" of clearance trimming) it might fit without slight trimming, but I am uncertain yet.

03-03-2007, 04:49 PM	#490
PBFAB.COM Senior Member Join Date: Dec 2003 Location: Mesa,Az Posts: 3,981	Re: Dropmember in a 69 C10 The Big Block mounts are done. I shipped the first Dropmember BBC combo out this week. The motor mount tabs for the BBC set up 3/4" higher than the SBC and the mounts themselves are all the same. I am yet to mock it all up in a cab to see exactly where the fit issues lie. I am assuming some slight mods to trans tunnel where it meets the firewall will be needed (maybe 1/2" of clearance trimming) it might fit without slight trimming, but I am uncertain yet. __________________ www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003!