|
Re: 6 lug Dana44 to 8 lug
3/4t spindles are different as well as everything from there out.In the 3/4t disc brake spindles there was the`71-`72 1st design and a 2nd design`72 where the moving parts will be different.You`ll need to know the axle model# off of the tube near the diff housing to the right.You`d do best to get the 2nd design as parts are tough on the 1st...no replacement spindles available and few good used.I can decode #s if you have them.A total axle swap would be the easiest way to go.Both these designs use the same identicle hubs(lock-outs)so you can`t go by that.They toatally interchange.
__________________
"BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed"
GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project)
GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling)
Tim
"Don't call me a redneck. I'm a rough cut country gentleman"
R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~
Last edited by special-K; 03-04-2007 at 12:37 PM.
|