View Single Post
Old 03-26-2007, 04:24 PM   #6
jimmydean
Registered User
 
jimmydean's Avatar
 
Join Date: May 2005
Location: Beaverton, OR
Posts: 3,728
Re: baggin questions

I ran a cup in the rear only because I decided to not cut the frame right now (and I had the cup anyway). I am waiting for the Porterbuilt C4 back half, so it seemed silly to do all the work to notch the frame only to change it all out later this year anyway.

I should have held off on the front as well (since I will likely run the C4 dropmember too), but live and learn.

So if you run a lower cup in the front and notch the back with the RE7 back mounted in place of the spring, you would have your ride height right about where my truck sits in that picture.
__________________
New Project: 1966 LWB C20
Plans:
1/2 ton conversion
Dropmember front
Dropmember rear
Corvette discs
Restored raised bed

http://67-72chevytrucks.com/vboard/s....php?p=4295210
jimmydean is offline   Reply With Quote