ok.. in that case guys. I will share with you all what I have so far. I found this website wit a pretty cool
LED Calculator . I tried a simple version of what I want done. I purchased a through hole circuit board and cut out a small section just attaching a 2x5 array of LED's and resistors as per the calculator results. Attached it to my power supply and it worked perfect!
I have yet to try it out with some superbrite wide-angle LED's but Im sure the results will be the same.
I plan on cutting the board to the appropiate shape and then soldering my LED circuit accordingly. After testing is completed then I will use a non-conductive epoxy to protect it from moisture.
What do you think??