View Single Post
Old 04-27-2007, 10:18 AM   #4
Yukon Jack
Post Whore
 
Yukon Jack's Avatar
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,689
Re: Front drive shaft - NP205 / Dana 20

Here's the thread I started a while back but it sure is confusing when I re-read it. I would be happy to get you measurements this evening of my K5's driveshaft installed with the 4 speed, NP205 and 4" lift.

As a side note, when I swapped in the NP205 in place of the Dana 20, I found the transfer case crossmembers must be different. I had to add 1" spacers to drop the Dana 20's crossmember down to be able to fit the NP205 in place.
__________________
1970 Blazer with a 400 sbc and 4" lift
1980 Pontiac Trans Am, 455 Oldsmobile
2012 Kawasaki Concours 14
Yukon Jack is offline   Reply With Quote