View Single Post
Old 06-06-2007, 10:41 PM   #5
lowdowndirtyshame67
Registered User
 
Join Date: Mar 2007
Location: Springfield, MO
Posts: 45
No problemo, senior...

First off, decide the wheel and tire size you want to go with. Something between 225/30/20 and 245/35/20 front and 225/30/20 up to as big as you want in the rear. Then lay it down. If you have notched the rear and spindled the front, you will be a few inches off the ground. If so, lose all your inner fenders (unbolt the front and rear and drill any spotwelds) and lay it down again. I would just leave the front inners out, but if not, you will have to fab your own because I haven't seen any aftermarket. Now, on the rears you have a million options...I think these trucks look best with normal drag style tubs in the rear and a raised pan over axle hump. Or you can just have a formed channel made at two 45 deg angles that goes across your bed (easiest)...Or you could just go crazy with it!!!!!!!!!!!!!!!
lowdowndirtyshame67 is offline   Reply With Quote