The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Joined the Short Wheelbase Club *69 Tahoe Project*

Frizzle Fry · 06-09-2007, 03:22 PM

Since this is my ONLY DRIVER

I had to keep it utilitarian. So here's some temporary 3/4" plywood in the rear. Slotted around the seat belts instead of locating the holes for ease of removal/installation.

I need to cut the lower rear section from a truck wheel tub to finish this one off where the spare tire well used to be. Duct tape for now

06-09-2007, 03:22 PM	#195
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: Joined the Short Wheelbase Club 69 Tahoe Project Since this is my ONLY DRIVER I had to keep it utilitarian. So here's some temporary 3/4" plywood in the rear. Slotted around the seat belts instead of locating the holes for ease of removal/installation. I need to cut the lower rear section from a truck wheel tub to finish this one off where the spare tire well used to be. Duct tape for now