Quote:
Originally Posted by jay6891
To keep your fingers from getting all nasty from spreading seam sealer with them. Dip your finger in thinner before you start and keep dipping as you work and it will not stick. The trick is to keep your fingers wet with thinner. Body man showed me that.
|
at the shop we work at we wear latex gloves or use a acid brush. it works the best. also not to sound like and expert but when you apply most any seam sealer. you should allways use a etch primer before you seam seal or a good epoxy primer. 99.9% of seam sealers dont have any zinc in them , and that s about the only thing to halt rust. most etch primers have alot of zinc. i have never seen a epoxy primer have zinc, but any primer is better than . just seam sealer over a weld. hope this helps