Re: HOWTO: Poor man's no-weld gas cap delete
Next, get a piece of steel stock. This will be used to brace the cap from the inside of the cab as shown in the next post.
I used a 5" wide piece of 1.5" wide 1/4" thick steel. I just happened to have it laying around - use whatever you want, just make sure it won't bend under stress.
I drilled a 21/64" hole dead center of the piece. You could use a 5/16" hole if you wanted, I just wanted some breathing room and had the odd sized bit laying around.
__________________
If I've got anything up for grabs, it'll be here: 7-hole gauge cluster for a 67-72 p/u FREE ( link)
I can't check the forum daily. If I don't reply to you within 24 hours, drop me a PM! I'm (hopefully) still alive and will reply faster to a PM.
Last edited by shifty; 07-07-2007 at 07:39 PM.
|