The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**jaros44sr** · 07-08-2007, 02:30 PM

Thanks for clearing the terminolgy up for me... in the old days a footwell would've been an area that you actually sat your feet into, like a jag e-type, oh well

Yeah, I had a hard time in that area too. It is a very critical area if you want your rocker panel to clear the door...

6 of one, 1/2 a dozen of the other, leaving the original metal in that area. There is less welding involved if you take it all the way up to the boltin high hump, plus it just looked easier...JMHO J.

I hit a wall for awhile, todo list comes first. J.

07-08-2007, 02:30 PM	#6
jaros44sr Senior Member Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,856	Re: Floor Pan Install Question Thanks for clearing the terminolgy up for me... in the old days a footwell would've been an area that you actually sat your feet into, like a jag e-type, oh well Yeah, I had a hard time in that area too. It is a very critical area if you want your rocker panel to clear the door... 6 of one, 1/2 a dozen of the other, leaving the original metal in that area. There is less welding involved if you take it all the way up to the boltin high hump, plus it just looked easier...JMHO J. I hit a wall for awhile, todo list comes first. J. __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 07-08-2007 at 02:35 PM.