|
Re: A-arm question pics inside!!
Quote:
|
....It seems like either N2trux or N2 billet did this on their truck I think.
|
Kens 77 already has the later style a-arms & his blazer has an aftermarket Scott's IFS. N2Billets 'old' truck is using the old crossmember from Kens blazer so it's also all later model parts.
The front alignment 'dowel' is the one that seats into the a-arm shaft. It works on the early 60's shafts all the way thru the 87's.
Seat the front dowel & make sure the rear of the shaft tightens up flush @ the top of the shaft & the bottom of the 'cup' it's centered within.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 07-08-2007 at 04:55 PM.
|