The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

crazy longhorn · 12-15-2002, 02:13 PM

I worked in a small muffler shop for a while, & most of the dual jobs were as longhornmail stated......custom bent. We used cards for the tailpipes where we could, but as a rule, from the manifolds to the muffs was a pretty easy shot & just custom bent to fit. I agree, some of thre smaller shops do very nice work. good luck.....crazy AL

12-15-2002, 02:13 PM	#5
crazy longhorn Fabricate till you "puke" Join Date: Jun 2002 Location: Ill Posts: 9,402	I worked in a small muffler shop for a while, & most of the dual jobs were as longhornmail stated......custom bent. We used cards for the tailpipes where we could, but as a rule, from the manifolds to the muffs was a pretty easy shot & just custom bent to fit. I agree, some of thre smaller shops do very nice work. good luck.....crazy AL __________________ 69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....